Part 15 Engineer

broadcast vision sold

almost everything on that list including rangemasters are long gone.

Broadcast vision still available and i have located a PSU for it.

well AR i was getting 1000 ft range with it outdoors in a weather proof enclosure 10ft off ground in very congested denver metro area, lots of interference from electronics other stations, 3 story wood and stucco apartment buildings all clustered together paved parking lot and i was still getting that range. i’m fairly confident that he would get…[Read more]

well AR i was getting 1000 ft range with it outdoors in a weather proof enclosure 10ft off ground in very congested denver metro area, lots of interference from electronics other stations, 3 story wood and stucco apartment buildings all clustered together paved parking lot and i was still getting that range. i’m fairly confident that he would get…[Read more]

the broadcast vision (I have one for sale) and decade both can have a range of 1000 ft radius. the decade retails for $600-$700 and the broadcast vision for about $3000, I also have a new revision broadcast vision for $160.00 shipped conus if you are interested. these two transmitters are FM spectrally clean, FCC certified, and if you get them up…[Read more]

email sent off to “@TheLegacy“

talking sign sold

talking sign sold

pics of talking sign (AM)

and Broadcast Vision (FM)

I have a broadcast vision FM as well and would make you a nice package deal on them.

at a minimum you would need a audio source (typically a computer) 12VDC regulated power supply, AM Audio processor and a 3m long antenna.

if you are going for minimum then am audio processor can run as a software program on computer.

i just listed a talking sign in the classifieds section,,,,

i now have hi res pics and schematics and parts are on order and will be here today. i’m good to go on arrival of parts.

i have a 1ghz  spec an, i can look at the harmonics and see what the transmitter is doing. that is how i knew the mods this guy did had screwed up the transmitter.

a pic of a stock board (remember mine is not stock) would help in tandem with the schematic as a confirmation of what belongs where. between the two using the board pics as a guide and schematic as a confirmation of what belongs where would go a long way to helping me fix the issues here. i have already begun to correct the topside using this…[Read more]

I got schematics and a board layout from him (had to sign an NDA so i can’t give them out) but the schematic lacks part location references such a T1, R4, Etc.

this is why i need the pics of a Rev. F board. i got the top of the board and have been fixing the board based on what i have already but i need a hi res pic of the bottom to see what…[Read more]