Home › Forums › temp › Question About Sending Photograph Along With Message › One Little Humorous Note About This Gates Board
Total posts : 45366
You guys have heard all of the stories. The
board was a rusted hulk upside down in
a dumpster at a local station. There were
indications that animals had lived in there.
And I found it in the pouring rain.
As I have been doing my best to put it back
together, I have had to try just about everything
2 or 3 times to get it right. Wether it be electronic
or cosmetic – solutions would look OK at first
and then fail. So the only thing to do would be
to try again.
As I get the board ready so it can be photographed,
there is one thing I didn’t think of.
The board is supposed to open or shut in two places.
The controls can swing down so you can get into the
front. No problem there. What I didn’t expect is that
the top panel doesn’t fit right onto the board. The metal
is bent. So I was able to get the top panel attached with
some nuts and bolts. But it won’t swing shut because the metal
is bent in a couple of places. So I have to figure out how
to fix that.
I didn’t expect that. I love and hate this control board at
the same time.