Total posts : 45366
I’ve started the trial and error expiriments. I clipped the Q5 transistor, heated the solder and removed the pins, used the solder wick and cleaned out excess solder, and installed the new transistor. I powered the unit on, and went over to a nearby radio, and there is still no carrier signal. I checked the new transistor’s voltage, and It is the same as the previous transistor. Also, I tried peaking and the voltage on the trimmer, and it was still hovering around zero. This may be the cause;however, I forgot to mention that earlier. Or, could it possibly be Q2 or Q3?