Home › Forums › temp › Whip and Mast Inspection by FCC Agents › Copy of Rangemaster FCC Certification Paper
Total posts : 45366
It looks like the last line was cut off for some reason. I got this from a web search and that is how it was posted.
FEDERAL COMMUNICATIONS COMMISSION
WASHINGTON, D.C. 20554
GRANT OF EQUIPMENT AUTHORIZATION
Certification
Hamilton PCB Design 134 Wind Chime Ct. 20594, Raleigh, NC 27619 Date of Grant: 07/17/1998 Application Dated: 05/08/1998
Attention: Keith Hamilton
NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID
ONLY for the equipment identified hereon for use under the Commission’s Rules and
Regulations listed below.
FCC IDENTIFIER: NWXAM1000
Name of Grantee: Hamilton PCB Design
Equipment Class: Part 15 Low Power Communication Device Transmitter
Notes:
Grant Notes FCC Rule Parts Frequency Range (MHZ) Output Watts Frequency Tolerance Emission Designator
37 15 1.2 – 1.71 %
37: This device has shown compliance with new rules adopted under Docket 87-389 and is not affected by Section 15.37, transition rule.
TITLE 47–TELECOMMUNICATION CHAPTER I–FEDERAL COMMUNICATIONS COMMISSION PART 15–RADIO FREQUENCY DEVICES Subpart C–Intentional Radiators Sec. 15.215 Additional provisions to the general radiated emission limitations. (a) The regulations in Secs. 15.217 through 15.255 provide alternatives to the general radiated emission limits for intentional radiators operating in specified frequency bands. Unless otherwise stated, there are no restrictions as to the types of operation permitted under these sections. (b) In most cases, unwanted emissions outside of the frequency bands shown in thes